Replacing The Lamp And Cleaning/Replacing The Air Filter - Canon RS-CL07 Manual De Instalación

Replacing the Lamp and Cleaning/Replacing the Air Filter

This Ceiling-mount Hanger allows you to replace the lamp and clean/replace the air filter without dismounting the
projector.
● Before replacing the lamp or cleaning/replacing the air filter, be sure to turn off the projector and
unplug the power cord from the AC outlet and that the projector is cooled sufficiently.
● For details on how to replace the lamp and clean/replace the air filter, refer to the User's Manual
that came with the projector.
Caution
● Check the projection angle and the screen slant angle after replacing the lamp. For details on how
to adjust the angles, refer to page 11.
1 Hold the projector, and remove two wing
screws (A) and open the Base bracket
slowly.
2 Replace the lamp, or clean or replace the
air filter.
3 After completion of replacement of the
lamp or cleaning/replacement of the air
filter, lift up the projector, and close the
Base bracket then tighten the wing screw
(A).
Specifications
Horizontal projection angle
Adjustment
Vertical projection angle
rangee
Outer dimension of assembly
(excluding projection)
Weight (Ceiling-mount Hanger only)

Screen slant angle
222.7 mm (W）x 281.5 mm (D）x 175.8 mm (H)
RS-CL07
1
A
A
RS-CL10
1
A
A
RS-CL07
5° leftward or rightward
5° upward or 20° downward
± 5 °
0.7' (W) x 0.9' (D) x 0.6' (H)
3.7 kg/8.2 lbs
Filter cover
Lamp cover
Filter cover
Lamp cover
RS-CL10
5° leftward or rightward
5° upward or 20° downward
± 5 °
310.5 mm (W) x 276.2 mm (D) x 178.2 mm (H)
1.0' (W) x 0.9' (D) x 0.6' (H)
4.1 kg/9.1 lbs