Unit Reception; Unit Identification; Transport Damage; Storage And Preservation - Ingeteam Ingecon EMS Manager Manual De Instalación

Unit Reception

4. Unit Reception
Keep the unit in its packaging until immediately before installation.

4.1. Unit identification

The serial number (S/N) of the unit is indicated on the nameplate and on the label on its packaging.

4.2. Transport Damage

If the unit has been damaged during transport, proceed as follows:
1. Do not proceed with the installation.
2. Notify the distributor immediately within 5 days of receipt of the unit.
If ultimately the unit has to be returned to the manufacturer, use the original packaging.

4.3. Storage and Preservation

Failure to follow the instructions provided in this section may lead to damage to the unit.
Ingeteam accepts no liability for damage resulting from the failure to follow these instructions.
If the unit is not installed immediately after reception, the following points should be taken into account in order to
avoid damage:
• Keep the unit free of dirt (dust, shavings, grease, etc.) and away from rodents.
• Keep away from water splashes, welding sparks, etc.
• Cover the unit with a breathable protective material in order to prevent condensation due to ambient
humidity.
• Units in storage must not be subjected to weather conditions other than those indicated in Section "2.3.
Table of features".
• It is very important to protect the unit from chemical products which can cause corrosion, as well as from
salty atmospheres.
• Do not store the unit outdoors.
In order to ensure correct preservation of the units, they must not be removed from their original packaging until it
is time to install them.
In case of prolonged storage, the use of dry places avoiding, as far as possible, sharp changes in temperature is
recommended.
Deterioration of the packaging (tears, holes, etc.) prevents the units from being kept in optimum conditions before
installation. Ingeteam accepts no liability in the case of failing to observe this condition.
AAX2002IKH06_A - Installation manual
INGETEAM POWER TECHNOLOGY, S.A.
INGECON EMS Manager
IP20 2013
U: 230 VAC
F: 50 Hz
Ser.-Nr.: XXXXXXXXXXXXX
INGECON EMS Manager nameplate
Avenida Ciudad de la Innovación 13
31621 Sarriguren (Spanien)
www.ingeteam.com
Ingeteam
English - 35