GRE L4PL Manual De Instrucciones página 4

6. Put another bottom tread on a fl at surface with the grooved side facing up; then snap the two holders into the groove.
Note: The two holders need to be snapped into the groove in the same direction.
7. Fix the treads to the holders with screws with #10x1-1 / 4 .
8. Place the Lower Base on a level surface. Snap front barrier into the groove on the lower base facing round edge. Snap
back barrier into the groove on the lower base facing the straight side.
9. Slide upper brace over front barrier as shown. Slide upper brace through the groove in the Back Barrier and push down
lightly to secure.
10. Fix lower base of entrapment barrier into bottom step of the Inside portion of the Ladder with 2 pieces10 x 1-1/4#
screws.
Front barrier
Lower base
Upper brace
Fix the barrier on to these two positions
Holder
Fix the tread to holder with screws
Back barrier
Slide upper brace through the groove