Installation And Start-Up; Suggested Installation Diagram - DOSMATIC MiniDos Serie Manual De Operación

Fluid Filter (Required)
Install a ilter of 140 mesh (104 micron) or iner depending
on your luid quality to prolong the working life of the injector
and for the warranty to be valid.
Twist II Clean ilter that can be ordered with your injector.
®
Mounting Injector
Securely fasten your injector to a solid object such as a wall or in
a cold luid line. Note arrow on injector indicates luid low.
Backlow Preventor (Recommended)
Install one that meets local code requirements.
Pressure Safety Release Device (Recommended)
Prevents pressure from exceeding speciications of the unit.
Bypass Valve Set-up (Recommended)
Allows the injector to be taken off-line for maintenance
or storage when not in use.
Fluid-Hammer Arrester (Recommended)
Prevents luid-hammer damage to the injector when operating
quick closing solenoid, pneumatic or hand-operated ball valves
on the luid system.
Anti-Siphon Valve (Optional)
To prevent solution from being siphoned out (from the solution
container) into the feed lines when the upstream valve is shut off.
The anti-siphon valve must be installed on the downstream outlet.

Suggested Installation Diagram

PRESSURE
REGULATOR
(OPTIONAL)
BACK FLOW
PREVENTOR
(RECOMMENDED)
FILL VALVE
(OPTIONAL)

Installation and Start-up

Refer to Fig. 4 and Fig. 5
Dosmatic recommends a
DIRECTION OF FLOW
INLET FILTER
140 MESH / 104 MICRON
(MINIMUM REQUIRED)
PRESSURE
GAUGE
(OPTIONAL)
(B)
INLET VALVE
(RECOMMENDED)
PRESSURE SAFETY
DEVICE
(RECOMMENDED)
COVERED CONTAINER
Additional Siphoning Prevention
Place solution container on a level below the injector suction tube
itting. Using the inlet side as a shut-off valve could cause full
strength solution to siphon into the feed line.
Solution Container
Use any size container. A lid or cover is recommended. To connect
your solution container, gently push the end of the suction tube
onto the bottom of the suction tube itting assembly.
Place the ilter into the solution container at least 2" (5cm) from
the bottom and ill with at least 2" (5cm) of chemical solution.
Never Use Petroleum Based Lubricants
The injector is shipped with a thin coat of silicone around the
seals for ease-of-assembly. Petroleum based lubricants such
as Vaseline©, baby oil, WD40©, or motor oil on the O-rings or
any part of the injector should never be used as this can cause
particles to adhere and clog or damage the injector.
Check System for Leaks and Start-Up Procedures
!
Open the bypass valve (A), close inlet valve (B) and outlet
valve (C) to prevent luid low into the injector. SLOWLY
turn on the main luid line. Run luid lows between 5 -12 gpm
(11-45 l/m) through the plumbing system. Turn on all of the valves
located downstream from your injector to release trapped air.
SLOWLY turn on the inlet valve (B). Open the outlet valve (C) and
close valve (A). As luid travels through the injector, you will hear a
"clicking" sound. Check for leaks and correct if necessary.
Fig. 5
WATER HAMMER
ARRESTER
(RECOMMENDED)
BYPASS VALVE
(RECOMMENDED)
(A)
(C)
OUTLET
VALVE
(RECOMMENDED)
SUCTION TUBE
SOLUTION FILTER
2 IN (REQUIRED)
50 MM
ANTI-SIPHON
VALVE
(OPTIONAL)
6" minimum
FLOW CONTROL
VALVE @ OUTLET
(OPTIONAL)
English: 9