Speed Selection; Switching On And Off - Bosch GKT18V-20GC Instrucciones De Funcionamiento Y Seguridad

2610055543.qxp_GKT18V-20GC 5/26/20 4:37 PM Page 24
compartment
orientation. Note: Store the placeholder
D in a safe place. Reinsert the
placeholder again if the connectivity
module is removed.
- Next place new battery B on the top of
the connectivity module with the "+"
polarity facing up.
- Place the cover A over the battery and
turn it ¼-turn clockwise to lock using a
flat screwdriver or a coin.
USING THE 'BOSCH TOOLBOX' APP
The 'Bosch
downloaded from the App Store or Google
Play.
Install the 'Bosch Toolbox' app on your
mobile device or make sure you are running
the latest version of the app.
Launch the 'Bosch Toolbox' app on your
mobile device and click on "My Tools"
icon/tile. Follow the app directions to pair
the tool with the mobile device.
BENEFITS SUMMARY OF
CONNECTIVITY MODULE AND APP
When used with the connectivity module,
the 'Bosch Toolbox' app will allow for the
following with the tool:
– Registration and personalisation
– Status check and warning messages
– General information and settings
– Adjusting the speed levels
The help button on the app explains
the features of the app.
The info button on the app displays
tool information and specifications.
The alerts button displays any alerts
received from the tool.
Basic operations
The torque from the motor can cause the
tool to twist.

SPEED SELECTION

The required speed can be preselected
with the user interface 20 before the
operation (Fig. 24).
The required speed depends on the saw
blade being used and on the material being
cut (see overview of saw blades at the end
Operating Instructions
observing correct
Toolbox' app can
When starting the tool,
hold it with both hands.
of these operating instructions).

SWITCHING ON AND OFF

To start the machine, first push the lock-off
button for the On/Off switch 2 and then
press the On/Off switch 1 and keep it
pressed.
Actuating lock-off button 2 releases the
plunging device at the same time, and
allows for the saw to be pushed down. This
makes the saw blade plunge into the
workpiece. When pulling up, the saw
retracts to the starting position and the
plunging device is locked again.
be
To switch off the machine, release the
On/Off switch
Note: For safety reasons, the On/Off switch
1
cannot be locked on; it must remain
pressed during the entire operation.
Your saw should be running at the desired
full speed BEFORE starting the cut, and
turned off only AFTER completing the cut.
To increase switch life, do not turn switch
on and off while cutting.
General Cutting Instructions
been released, be aware of the nec es -
sary time it takes for the blade to come
to a com plete stop during coast down.
Be aware of the blade exposure.
Always hold the saw handle with one hand
and the auxiliary handle or housing with the
other.
Ensure workpiece is securely clamped.
Maintain a firm grip and operate the switch
with a decisive action. Never force the saw.
Use light and continuous pressure.
Always allow the blade to reach the full
speed (as set on the speed dial) before the
blade contacts the workpiece. Unless a
plunge cut is required, lower the saw blade
to the preset depth before moving the saw
forward and into the workpiece.
When cutting is interrupted, to resume
cutting: squeeze the trigger and allow the
blade to reach full speed, re-enter the cut
slowly and resume cutting.
When cutting across the grain, the fibers of
the wood have a tendency to tear and lift.
Advancing the saw slowly minimizes this
effect. For a finish cut, a crosscut blade or
miter blade is recommended.
24
1
.
After completing a cut
and the trigger has