Safety Symbols; Safety Instructions - Bosch GTA47W Instrucciones De Funcionamiento Y Seguridad

2610047964.qxp_GTA47W 6/29/17 10:57 AM Page 2
The definitions below describe the level of severity for each signal word. Please read the manual
!
instructions listed below may result in serious
personal injury.
Fully assemble and tighten all the fasteners
required for this stand. Periodically check
that all fasteners are attached and
adjusted according to the assembly
instructions included in this manual. A
loose stand is unstable and may shift in use
and cause serious injury.
Turn tool switch off and disconnect power
before mounting to the stand. Unintended
startup during assembly can cause injury.

Safety Symbols

and pay attention to these symbols.
This is the safety alert symbol. It is used to alert you to potential
personal injury hazards. Obey all safety messages that follow this
symbol to avoid possible injury or death.
DANGER indicates a hazardous situation which, if not avoided, will
result in death or serious injury.
WARNING indicates a hazardous situation which, if not avoided, could
result in death or serious injury.
CAUTION, used with the safety alert symbol, indicates a hazardous
situation which, if not avoided, will result in minor or moderate injury.

Safety Instructions

Read all instructions.
Failure to follow
Before operating make sure the entire unit
all is placed on a solid, flat, level surface.
Serious injury could occur if tool is unstable
and tips.
Never stand on tool or its stand or use as
ladder or scaffolding. Serious injury could
occur if the tool is tipped or the cutting tool is
accidentally contacted. Do not store materials
on or near the tool such that it is necessary to
stand on the tool or its stand to reach them.
Use only Bosch replacement parts. Any
others may create a hazard.
-2-