Operation (continued)
Adjusting the DUALBRITE
7
Switch
The "DUALBRITE" switch determines the amount of
time the lights stay on at a reduced light level after
sundown. Switching this setting to "OFF" will not
effect the "ON-TIME" setting.
Set the "DUALBRITE" switch to OFF, 3 hours, 6
hours, or dusk-to-dawn (sunset to sunrise).
MODE
OFT FLASH
DUAL BRITE™
OFF 3 6 DUSK TO
HOUR
DAWN
9
Using Manual Mode
Manual mode overrides the motion sensor (C) and
"ON-TIME" control so the light will operate full bright.
This feature only works at night and only for one night
at a time. The motion sensor (C) will reset to motion
sensing mode at sunrise. Manual mode can be toggled
on and off using a wall switch.
To turn manual mode on, switch the light off
at the wall switch for 3 to 4 seconds and then
back on.
To turn manual mode off, switch the light off
at the wall switch for 3 to 4 seconds and then
back on.
NOTE: If the power to the light fixture is off for more than
5 seconds, allow the motion sensor to warm up prior to
switching to manual mode.
8
The "LAMP MODE" switch determines the way the
lights will turn on when motion is detected.
C
Turn the switch
OFF for 3 to 4
9
Please contact 1-866-308-3976 for further assistance.
Adjusting the LAMP MODE
Switch
Security ("NORMAL") - Light comes on instantly.
BulbSaver ("SOFT") - Light comes on dim and
gradually increases to full brightness. When the
light turns off it will gradually dim to half-bright,
pause, and then will continue dimming until the
light turns off.
AlertFlash ("FLASH") - Light flashes on then off
twice before turning on full brightness.
Set the "LAMP MODE" to "NORMAL", "SOFT",
or "FLASH" position.
LAMP MODE
NORMAL SOFT FLASH
seconds
C
Turn the
switch
back ON
HOMEDEPOT.com