Samsung DVE50R8500 Manual Del Usuario página 58

Troubleshooting
Problem
Has odors.
Lint on clothes.
Items still wrinkled
after Wrinkle Prevent
(Wrinkle Away, Wrinkle
Release).
Water drips from the
nozzle when the Steam
cycles starts.
Sprayed water is not
visible during Steam
cycles.
Extended time.
If a problem persists, contact a local Samsung service center.
58 English
Untitled-4 58
• Household odors from paint, varnish, strong cleaners, etc.
may enter the dryer with the surrounding room air. This is
normal as the dryer draws the air from the room, heats it,
pulls it through the tumbler, and exhausts it outside.
• When these odors linger in the air, completely ventilate the
room before using the dryer.
• Use the REFRESH cycle. If odors persist, wash and dry the
items again.
• Make sure the lint filter is cleaned before every load. For
clothes that naturally build up lint, clean the filter during
the cycle.
• Some fabrics are lint producers (for example, a fuzzy white
cotton towel) and they must be dried separately from
clothes that are lint trappers (for example, a pair of black
linen pants).
• Divide larger loads into smaller loads for drying.
• Check pockets thoroughly before drying, then dry clothes.
• Remove lint inside the drum before drying a load.
• Small loads of 1 to 4 items work best.
• Load fewer items. Load similar-type items.
• Take out the items immediately after drying is complete.
• This is steam condensation. The dripping water will stop
after a short time.
• Sprayed water is difficult to see when the door is closed.
• Sensor Dry automatically senses the moisture in the load
and shuts the dryer off when the selected dryness level is
reached. The drying time can change according to the type
and amount of laundry. See the cycle chart for reference.
Action
2019-09-16 4:50:42