Descargar Imprimir esta página

Environmental Protection - Crown CT36046 Manual Original

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 24
than 12 months, it is also recommended to change the
oil before operation�
Attention: If the oil changed its color (it
became light - water entered it, or it be-
came dark - it got overheated) or there
are foreign impurities in it, you must im-
mediately change it.
• Place the appliance on a flat horizontal surface.
• Under the drain hole, place a container, into which
the used oil will drain (see fig. 7.2).
• Using a cloth, clean the area around plug 8 and un-
screw it (see fig. 7.1).
• Using a cloth, clean the area around plug 3 and un-
screw it, and wait until the used oil stops flowing out of
the drain hole� Screw in plug 3 (see fig. 7.2).
• Carefully pour the oil into crankcase 19 (it is recom-
mended to use a funnel)� The oil level is the upper limit
of the red point on viewport 20 (see fig. 6.2). Atten-
tion: do not exceed the maximum level mark.
• Screw in plug 8 (see fig. 7.1).
Draining condensate (see fig. 9-10)
After each using or after working day, always drain the
condensate from receiver 17� This prevents from cor-
rosion inside receiver 17�
• Place the appliance on a flat horizontal surface.
• Place a container under drain valve 22, where the
condensate will drain�
• Unscrew drain valve 22 and wait until the conden-
sate has drained completely (water will stop dripping
from valve 22) (see fig. 9-10).
• Screw in drain valve 22�
Cleaning air filter (see fig. 11-12)
Regularly inspect filter element 36 of air filter 18 (its
contamination depends on the state of the environ-
ment). Clean (or replace) the filter element as it gets
dirty, but at least after 100 hours of using the ap-
pliance. A polluted air filter reduces efficiency factor
and contributes to a greater depreciation of the ap-
pliance�
• Place the appliance on a flat horizontal surface.
• Unscrew air filter 18 (see fig. 11-12).
• Remove cover 37 from housing 35�
• Remove filter element 36�
• For models CT36028, CT36029: wash filter ele-
ment 36 with water and soap, and dry it thoroughly� At-
tention: Do not use gasoline, solvents or corrosive
substances to flush the filter element.
• For models CT36046, CT36047: blow filter ele-
ment 36 with compressed air�
The manufacturer reserves the possibility to introduce changes.
• If the impurities of filter element 36 are too heavy
and cannot be cleaned, replace it. It is strictly forbidden
to use the appliance without an air filter.
• Assemble air filter 18 and install it back.
Checking the receiver status
Regularly inspect receiver 17 for signs of damage or
corrosion. If receiver 17 is damaged, it is forbidden
to perform independent repairs (mechanical, or by
welding)� Damaged receiver 17 must be completely
replaced at the dedicated CROWN repair workshop.
After-sales service and application service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts. Information about service centers,
parts diagrams and information about spare parts can
also be found under: www.crown-tools.com.
Transportation of the appliances
• Only move the аppliance by handle 1 or by picking
it up and supporting from the bottom� Do not move the
аppliance by other parts (by pulling the hoses or power
cable, etc�)�
• Do not transport or move the appliance without re-
lieving pressure from the receiver 17�
• Categorically not to drop any mechanical impact on
the packaging during transport.
• When unloading / loading is not allowed to use any
kind of technology that works on the principle of clamp-
ing packaging.

Environmental protection

Attention: Do not dispose of the used oil,
as well as condensate from receiver 17,
on the soil, into the ground, water bod-
ies or wastewater sewerage. The used oil
must be collected in a sealed container and trans-
ferred to a process waste collection point for fur-
ther disposal.
Recycle raw materials instead of dispos-
ing as waste.
Appliance,
should be sorted for environment-friendly
recycling�
The plastic components are labelled for categorized
recycling�
These instructions are printed on recycled paper man-
ufactured without chlorine�
English
16
accessories
and
packaging

Publicidad

loading

Este manual también es adecuado para:

Ct36028Ct36029Ct36047