Installing Your Freezer; Installing Casters - Amana Deepfreeze LW-120 Manual Del Usuario

All manuals and user guides at all-guides.com

Installing Your Freezer

1. Remove all packaging material. This includes the foam base and all
adhesive tape holding the freezer accessories inside and outside.
2. Inspect and remove any remains of packing, tape or printed materials
before powering on the freezer.
3. Select a suitable location for the freezer on a hard even surface away
from direct sunlight or heat source e.g. radiators, baseboard heaters,
cooking appliances etc. Any floor unevenness should be corrected.
4. Do not install your freezer in any location not properly insulated or
heated e.g. garage etc. Your freezer was not designed to operate in
temperature settings below 32˚ F (0˚C).
5. Your freezer is designed for freestanding installation only. It should not
be recessed or built-in.
6. Place the freezer on a floor strong enough to support it fully loaded.
7. When moving the freezer, never tilt it more than a 45-degree angle.
This could damage the compressor and the sealed system.
8. In case you unplug your freezer or experience an electrical outage,
allow 5 minutes before plugging it back in.

Installing Casters

• Casters are to be installed on the 4 bottom corners. Slide caster in the
provided slot. Once the caster is in place, secure it with a provided
screw.
Note: 1 Phillips Head screwdriver required.
English
English
Screw
6