Safety Features; Child Safety - Taurus TLV 5555 Manual De Instrucciones

English
d) The machine is filling with water and draining at the same time.Check that:
- The drainage hose is positioned at the right height (Section 2.2) and that it is not syphoning
because the diameters of this hose and the drain where it is resting are very tight.
e) The machine is vibrating or making a lot of noise. Check that:
- The block release operation has been carried out (Section 2.1).
- The washing machine is properly levelled (Section 2.3).
- The washing machine is not vibrating due to contact with furniture or a wall.
f) The machine is leaking water. Check that:
- The f ilter cap is tightly closed and with the trim in ist place.
- The inlet hose is tightened on both sides and with the trim in ist place.
- The detergent used is loose powder and is not forming lumps which clog the soap drawer.
- The washing machine is well levelled and not leaning forwards.
g) The machine is not washing to your satisfaction. Check that:
- You have chosen the right temperature an program.
- You are using the right dose of detergent.
- The f ilter is not clogged and so the rinses are not working properly.
h) If the loading door will not open, remember that:
- The pilot lamp (if there is one) must be off. If it is not, press the button to the STOP
position and wait about two minutes before trying to open it.
If after making these checks, the doubts or abnormalities continue, then call our Technical
Assistance Service who will attend to you as soon as possible.
The telephone number can be found in the control list of Technical Assistance Services,
or on the own machine customer attention and Technical Service DIRECT LINE label.

6- Safety features

6.1 - The door
An electro-mechanical safety device prevents the door from
opening whilst the appliance is operating,thus preventing access to the inside of the
machine and the consequent danger of injuries to the hands from coming into contact
with high temperatures or from the movement of the drum.
6.2 - The wash motor
In the event of mechanical underload or overload,a thermal safety device automatically
protects the motor.
6.3 - Heating
Heating of the wash water cannot star t until the required water level is reached.
If there is not enough water or the tap is off,the machine stops (the program does not
move forward).
A safety thermostat prevents excess temperatures.
6.4 - Plumbing.Water inlet
In the event of the f ilter being blocked the machine will never overflow.

6.5 - Child safety

The accesses to the door and to the pump motor f ilter are protected against any
accidental handling by children.
41