Input And Control Section - dBTechnologies INGENIA IG4T Manual Del Usuario

English

INPUT AND CONTROL SECTION

1. "PEAK" LED
Red LED that lights up briefly when connecting power or in
case of audio limiter operation.
ATTENTION!
Never use the speaker for a prolonged
time while the limiter LED is on or
blinking, indicating the equipment is
running under excessive stress conditions
with distorted sound.
2. OLED DISPLAY
The display automatically orientates according to the
accelerometer control, detecting whether the speaker has been installed
straight vertically or flipped. The user can configure a contrast adjustment and automatic power-off function (see
chapter CONTROL PANEL AND SETTING
3. PUSH ROTARY ENCODER
The push rotary encoder allows both a rotary selection (selection of menus and values), and a push selection
(selection confirmation) to navigate the menus.
4. USB SERVICE DATA
The type B mini-USB B port allows to update the product firmware. For further information, please refer to
the Web site http://www.dbtechnologies.com in the "DOWNLOADS" section and to chapter
FIRMWARE)
ATTENTION!
The USB SERVICE DATA connection must only be used to update the
product firmware; never connect any USB device to the equipment, to
avoid possible damages or malfunctions.
5. "LINK" OUTPUT
Balanced "XLR" output, allowing to send the input audio signal to another amplified speaker.
6. "INPUT" COMBO INPUT
Combined XLR-TR-TRS audio signal input. It allows to use a balanced XLR connector, or a ¼" TS or TRS jack input.
ATTENTION!
Only use cables equipped with high-quality Neutrik® original
connectors. Using different or poor-quality connectors might affect
the speaker operation.
7. "INPUT SENSITIVITY" SELECTOR
A selector allowing to set whether the incoming signal comes from a mixer/a line ("LINE") or from a microphone
("MIC").
INGENIA IG4T
MENUS).
UPDATING THE
Cod. 420120235 REV. 1.2
45