Cobra microTALK PR 945 DX Instrucciones Operativas página 6

A D VA N C E D O P E R AT I O N
Using the Scan Function
CHANNEL
To scan privacy codes:
SELECT
Button 1. While in Standby mode, press the CHANNEL SELECT
button up or down to choose the main channel you
wish to scan.
2. Press the MODE button until the Scan icon and the
MODE
Button
privacy code number flashes.
3. Push the CHANNEL SELECT button up or down and the
radio will begin scanning privacy codes within the main
channel you selected.
4. The radio will continue to scan privacy codes and stop if
an incoming transmission is detected. The radio will
remain on that code for ten (10) seconds. During that
time you can:
CHANNEL
a) Press and hold the TALK button and talk. The radio
SELECT
will remain on that channel and privacy code, then
Button
return to Standby mode.
b) Push the CHANNEL SELECT button up or down to
resume scanning privacy codes.
c) Press the MODE button to proceed to memory
location scanning (see below).
If you do not press any button within ten (10) seconds,
the radio will automatically resume scanning privacy codes.
To scan memory locations:
MODE
1. Press the MODE button until the Scan icon,
Button
Location icon and memory location number flashes.
2. Push the CHANNEL SELECT button up or down and the
radio will begin scanning memory locations.
3. The radio will continue to scan all
and stop if an incoming transmission is detected. The
radio will remain on that location for ten (10) seconds.
During that time you can:
a) Press and hold the TALK button and talk. The radio
CHANNEL
will remain on that memory location channel and
SELECT
return to Standby mode.
Button
9
ENGLISH
(continued)
Memory
memory locations
ENGLISH
A D
b) Push the CHANNEL SELECT button up or down to
resume scanning memory locations.
c) Press the MODE button to proceed to other functions.
If you do not press any button within ten (10) seconds,
the radio will automatically resume scanning memory
locations.
You must have at least two (2) memory locations
programmed in order to scan memory locations.
(NOTE: If you want to reduce the number of
locations being scanned you need to "unprogram" all
unwanted locations by changing both the main channel and
privacy code to 00. See Programming Memory Locations,
page 7.)
"Roger Beep" Confirmation
Your listener will hear an audible tone when you release
the TALK button. This alerts the other party that you are
finished talking and it is OK for them to speak. This feature
can be turned On or Off.
To turn "Roger Beep" On or Off:
When turning On your microTALK
"Roger Beep" will be On.
MODE
Button
1. Press the MODE button until the "Roger
flashes on the LCD. The current On or Off setting is
displayed.
2. Press the CHANNEL SELECT button up or down to select
"Roger Beep" On or Off.
3. a) Press the MODE button to enter the new setting and
proceed to other functions.
b) Press the LOCK button to enter the new setting and
CHANNEL
return to Standby mode.
SELECT
c) Do not press any buttons for 15 seconds to enter the
Button
new setting and return to Standby mode.
The setting you select will be saved when you turn your
radio Off and On again. When the "Roger Beep" is On, the
"Roger Beep" icon will be displayed.
VA N C E D O P E R AT I O N
memory
Tone
® radio for the first time,
Beep'' icon
10