Setting Up; Inserting/Replacing And Testing Batteries; Using Rechargeable Batteries - AKG SO 40 Modo De Empleo

3 Setting Up

3.1 Inserting/Replacing and Testing
the Battery (refer to fig. 2)
1. Depress the snap hook on the battery com-
partment lid (1).
2. Pull the battery compartment lid (1) down to
remove it from the transmitter.
L
Important!
!
The foam pad on the inside of the bat-
tery compartment lid (1) holds the
battery in place. Do not remove the
foam pad. If you do, the battery will
not be held in place properly and may
cause a rattling noise.
3. If there is a dead or defective battery inside the
battery compartment, remove the battery.
4. Insert the supplied or new battery (2) into the
battery compartment as shown in fig. 2.
5. Set the ON/MUTE/OFF switch (3) to ON.
14
Fig. 2: Inserting the battery.
The status LED (4) will flash momentar ily. If the
battery is in good con dition, the status LED (4)
will extinguish.
If the status LED (4) lights constantly the bat-
tery will be dead within about 60 minutes.
Replace the battery with a new one as soon as
possible.
If the status LED (4) fails to flash momentarily
the battery is dead. Insert a new battery.
6. Slide the battery compartment lid (1) onto the
transmitter against the direction of the arrow to
the point that the lid (1) will click shut.

3.2 Using Rechargeable Batteries

Instead of dry batteries, you can also use a 1.5-V
rechargeable battery to power the transmitter. We
recommend SANYO HR-4U (650 mAh) or
Panasonic Rechargeable PRO+ (550 mAh) NiMH
rechargeable batteries.
SO 40 snapon