Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
HOW TO USE THE AQUOLAB
1.
When using for the first time or after a long period of inactivity, perform
a vacuum cycle before using your dental water jet
2.
The device switches off automatically after 1 min/1.5 min to prevent
water-free operation
3.
Fill the tank with water, about 300 ml.
4.
Insert your personal nozzle into the handle.
5.
When you push the ON button (c), the LED will flash to remind you to make sure that
there is water in the tank (h). If there is water in the tank, proceed to step 6.
6.
To turn the water flow ON/OFF, press the dedicated button. (e)
7.
To turn the ozone flow ON/OFF, press the dedicated button. (d)
8.
Press the button activating the water flow. (f)
9.
For children under 10 years of age the 0.8 mm diameter nozzle is strongly recommended.
10. If you have high dentine sensitivity, use the 0.8 mm diameter nozzle.
HOW TO REGULATE WATER AND OZONE LEVELS
Once you have switched on your device, you can regulate/modify the levels of water and ozone
by following these steps:
•
Press and hold down the C and D buttons SIMULTANEOUSLY for 3 seconds.
•
The orange light (J) will come on.
•
To set the water level, press button C. The LED will flash once or twice (level 1 or level 2).
To change the level, press button C for a second time.
•
To set the ozone level, press button D. The LED will flash once or twice (level 1 or level 2).
To change the level, press button D for a second time.
•
Once you have set the desired levels, unplug the device, wait for a few seconds, then plug
it back in. Now your Aquolab will operate and it will save the levels you have selected.
These are just general recommendations. For specific needs, contact our Customer Service by
calling number: +39 02 366 86 416 or writing an email to: assistenza@aquolab.com
DENTAL WATER JET
®
Publicidad
Tabla de contenido
