Control Modes - baltur BGN 60 Lx Guía Rápida

Control Panel ACS 100-PAN
The control panel can be connected to and detached from the converter at any time.

Control modes

Active fault indicator
Display modes
START/STOP
REVERSE
Control Modes
The very first time the drive is powered up, it is controlled from the Control Terminals (remote control, REM).
The ACS ... is controlled from the control panel when the drive is in local control (LOC).
Switch to local control (LOC) by pressing and holding the MENU and ENTER buttons down simultaneously
until first Loc or later LCr is displayed:
Start and stop the drive by pressing the START/STOP button.
Change the shaft direction by pressing the REVERSE button (parameter 1003 must be set to REQUEST).
Switch back to remote control (REM) by pressing and holding the MENU and ENTER buttons down
simultaneously until rE is displayed.
22
FREQUENCY CONVERTER
UP/DOWN
Units
Shaft direction
MENU
ENTER