Kathrein EXR 1708 Manual Del Usuario página 4

Multi-switch
EXR 1708
EXR 1718
Cascadable multi-switch for splitting 16 sat levels and terrestrial

signals to multiple receivers
Only one downlink per receiver needed

(two for twin receivers)
Facility to select horizontal/vertical, low/high, sat positions A/B/C/D

independently for each receiver using DiSEqC
If not using DiSEqC TM controls, changing the horizontal/vertical,

low/high of sat position A can be performed, also by tone burst
changing sat position A/position B
Integral amplifi er for low attenuation in sat signal band

Integral pre-emphasis to equalise cable attenuation

Terrestrial signals also receivable with sat receiver switched off

Terrestrial range 5-862 MHz passive

High degree of insulation between outputs

Can be remote fed via the horizontal low inputs.

All other inputs are voltage-free
(enabling operation with UAS 485)
For indoor installation

EXR 1708
Multi-switch for 8 connections, with integral power supply unit

Low power consumption based on high-effi ciency short-circuit-

proof switch-mode power supply unit
Can be extended using EXR 1718

EXR 1718
Multi-switch loop-through for system extension to eight

connections each
Highly cascadable (up to 40 connections)

Settings for receivers with DiSEqC™
Setting
DiSEqC™ "On"
22 kHz and tone burst to "Off"
Settings for receivers without DiSEqC™
Setting
22 kHz → High/Low
Tone burst → Pos. A/B
The terms for the settings in the receiver menus are specifi c to the respective model and manufacturer!
Sat-IF distribution system (16 x Sat-IF)
Multi-switch
20510027
20510028
controls
TM
Effect
All inputs can be selected
Changeover time is shortened
Effect
All position "A" inputs can be selected
All position "A" and "B" inputs can be selected
EXR 1708
20510027
EXR 1718
20510028