Water Temperature Setting; Time Setting; System Time Setting; Timer Setting - Gree XK64 Manual De Usuario

the HOTWATER mode will be started upon restart of the water heater in the case of
blackout.

6.4 Water Temperature Setting

In the On state, press ▲ to increase or press ▼ to decrease the temperature
setpoint. The water temperature will increase or decrease continuously by 1° C when
the button is pressed and held.
The minimum temperature setpoint for all models is 35° C. The maximum
temperature setpoint can be set to 55° C, 58° C, or 70° C. For details, see the Integrated
Unit User Manual.

6.5 Time Setting

6.5.1 System Time Setting

In the main interface, press and hold the TIMER button for 5 seconds. The system
time setting interface is displayed. The clock icon is on and the hour value blinks. Press
▲ or ▼ to adjust the hour value and press the TIMER button to confirm setting. Then
the minute value flickers. Press ▲ or ▼ to adjust the minute value and press the
TIMER button to confirm setting. After system time setting is saved, the main interface
is displayed. In the setting process, if no button is pressed within 15 seconds, the main
interface will be displayed and setting will not be saved.
The system time ranges from 00:00 to 23:59. Each time you press ▲ or ▼, the
time increases or decreases by 1 hour or 1 minute. When the button is pressed and
held, the time increases or decreases continuously by 1 hour or 1 minute.
The setting process is shown in the following figure.
Press and hold the
Main interface
TIMER button.

6.5.2 Timer Setting

Timer setting: Under the HOTWATER or SAVE mode or under the Off state,
Controller For The Air Source Heat Pump Water Heater
Hour value of the
Press the TIMER
system time
button.
blinks.
7
Minute value of
Press the TIMER
the system time
button.
blinks.
Setting is
complete.