Descargar Imprimir esta página

Surtek 107997 Manual De Usuario página 3

Publicidad

GENERAL SAFETY RULES
Your AIR COMPRESSOR has many features that
will make your job faster and easier. Safety, per-
formance and reliability have been given top pri-
ority in the design of this tool, qualities to make
easy to maintain and to operate.
WARNING: Read and understand all instruc-
tions. Failure to follow all indications listed below,
may result in electric shock, fire and/or serious per-
sonal injury. SAVE THESE INSTRUCTIONS.
SPECIFIC SAFETY RULES FOR
AIR COMPRESSORS
WARNING: Disconnect the compressor from
the cigarette lighter socket before changing acces-
sories, servicing or performing any maintenance.
WARNING: Use only the supplied adaptors.
• Maintain the compressor in good condition, DO
NOT use if damaged.
• Ensure that there are no flammable or combus-
tible materials (including gases) near the compres-
sor when in use.
WARNING: This compressor is capable of high
pressure. DO NOT exceed the maximum safe pres-
sure of the item being inflated.
• Allow your compressor to cool after use and
store in a safe, dry, childproof area with the con-
nector locking lever in the unlocked position.
• Do not expose this device to long periods of
moisture or direct sunlight. Doing so will affect
normal operation and, in some extreme cases, en-
danger the user.
• Do not disassemble the product.
• Any misuse of the product will void warranty.
If you believe the compressor has malfunctioned
or requires repair, please refrain from attempting
to repair it yourself. Contact the authorized ser-
vice center.
FEATURES AND OPERATION
· To avoid draining the vehicle battery, please
keep the engine running while the air compres-
sor is used.
· Make sure the power switch is in the "OFF" posi-
tion when not in use.
12 Volt motor compressor with emergency light.
Easy-read gauge shows pressures up to 300 psi
(21,1 bar). Supplied with power cable with in-line
rotary power switch and plug for use in cigarette
lighter socket, high pressure hose with clip-on
connector and accessory kit including ball needle
and adaptors for inflatables.
E N G L I S H •
TIRE INFLATION
• To achieve optimal performance when operating
your air compressor, your vehicle's engine should
be running.
• Plug the compressor power cord into the 12 V
power outlet of your vehicle. Screw the brass valve
tip of the air hose directly onto the tire air valve.
• Turn the compressor 'ON'. The tire will begin to
inflate.
• When the pressure gauge reaches the desired
pressure, switch the unit 'OFF' and remove the air
hose from the valve (normal tire pressure is 28-35
PSI).
WARNING: The compressor must be switched
off for fifteen minutes after each sixty minute pe-
riod of continuous operation to prevent excessive
heat build-up.
IMPORTANT: When inflating a totally flat tire still
fitted on a vehicle, there should not be any weight
on it. The vehicle must, therefore, be jacked up
to take the weight off the tire. The time taken to
inflate a tire will depend upon the volume of air
and pressure required. If the compressor does not
work when it is plugged in, check the operation
of the lighter socket, it may require the ignition
switch to be in the 'ON' position for it to work.
INFLATABLES
Inflating other items such as bicycle tires, air beds,
sports balls etc. Start your vehicle engine and then
plug the compressor's power cord into the 12 V
power outlet.
Nozzles are provided to fit most inflatable objects.
Simply screw the appropriate nozzle into the brass
tip of the air hose.
Attach the appropriate nozzle to the inflatable
object and turn the compressor 'ON'. When the
object is inflated
to the desired firmness or pressure, turn the com-
pressor 'OFF'.. TAKE CARE NOT TO OVER-INFLATE.
TECHNICAL DATA
VOLTAGE
AIR PRESSURE
U se r ' s m an ua l
12 V
300 PSI (21,1 km/cm²)
3

Publicidad

loading