General Information; Installing The Batteries - Hozelock Sensor Controller Plus 2214 Instrucciones De Instalación Y Funcionamiento

GB
A 21mm G½ (½"bsp) Adaptor
B 26.5mm G¾ (¾"bsp) Adaptor
C 33.3mm G1 (1"bsp) Adaptor
D Schedule dial
E Duration dial
F LED indicator lights
G Water Now button - On/Off/Override
H Hose pipe connector
I Light Sensor
Installation & operating instructions
READ THESE INSTRUCTIONS CAREFULLY BEFORE
ATTEMPTING TO USE THIS PRODUCT.
FAILURE TO OBSERVE THE FOLLOWING NOTICES MAY RESULT
IN INJURY OR PRODUCT DAMAGE

General information

THESE INSTRUCTIONS ARE ALSO AVAILABLE ON THE
HOZELOCK WEBSITE.
This product meets the requirements of IP44 and therefore can
be used in exposed weather conditions.
This product is not suitable for supplying drinking water.
4
Threaded water connections are suitable for hand tightening
only.
This product can be fitted to mains water supply.
This product can be fitted to outdoor water butts or tanks that
have an inline filter fitted before the controller.

Installing the batteries

You must use Alkaline batteries – alternatives will result in
incorrect operation.
Remove the front panel as shown (Fig. 1), gripping the recessed
1
part and pulling towards you.
2 Insert 2 x 1.5v AA (LR6) batteries (Fig. 1) and replace the
controller front panel.
IMPORTANT: Rechargeable batteries must not be used.
Replace batteries each season. (max 8 months use, used twice a
3
day)
4 When batteries are installed the motor will operate the internal
valve to check that it is ready for use and the batteries installed
have enough charge to safely operate the valve
If the LED indicator flashes red, the batteries need to be
5
replaced.
Connecting the Sensor Controller Plus to the tap
Choose the correct tap adapter. (Fig. 3)
1
Using the correct adapter(s), attach the controller to the tap and
2
tighten firmly to avoid leaks. Do not use a spanner or other tool
to tighten as this might damage the threads. (Fig. 4)