Connecting To Other Cradles - Symbol CRD3100-1000 Guía Rápida

8
Recharging the Terminal's Battery
Note: The procedure for recharging the battery in the single-slot
cradle is the same as for the four-slot cradle.
• The NiCad battery is automatically recharged whenever
the terminal is properly inserted in the cradle. The
terminal may be on or off.
• The terminal must be left in the cradle up to 90 minutes to
recharge a fully discharged battery.
Do not charge if battery temperature is below 0°
C (32° F). If below 0° C, wait one-half hour for
battery to warm up.
• The terminal contains a safety mechanism so that
disposable alkaline batteries are not charged.

Connecting to Other Cradles

Up to 16 four-slot cradles can be connected in series using an
RS-232 inter-cradle cable (p/n 60427-00-00). For
interconnecting cradles where a longer inter-cradle cable is
needed, use cable p/n 51349-00-00. Single-slot cradles may
not
be interconnected.
Each cradle must have its own power supply; any
other method of power hookup is unsafe.
1. Plug one end of the inter-cradle cable into the
communication port located on the right end of the first
cradle.
Quick Reference
Caution
Warning