Battery Charge Level; Troubleshooting; Cleaning And Care - FLORABEST HG00549 Instrucciones De Utilización Y De Seguridad

System time
–
Irrigation start time 1
–
Irrigation duration 1
–
Irrigation start time 2
–
– Irrigation duration 2
Irrigation interval (every day, every 2nd day,
–
every 3rd day, etc.)
Standby (Programming mode terminated and
–
irrigation programme active).
After about 1 minute without any entries being made,
¾
the appliance returns to standby mode. All values
that have already been programmed are retained.
By briefly pressing the
¾
back one step in the programming mode to make
adjustments to the programmed values.
By pressing and holding the
¾
terminate programming mode and the values that
have already been programmed will be retained.
Press the button to stop irrigation that is already
¾
in progress.
§ Battery charge level
In the event of a low battery charge level,
¾
the symbol flashes. All other displays are
C
deactivated.
symbol flashes on the display
The batteries are flat.
Valve does not open.
The appliance cannot carry out irrigation.
The batteries must be replaced
(→ Inserting/replacing the batteries).
For as long as the
¾
not possible. Irrigation that may be in progress will
be terminated.
The programming is saved for 120 seconds. If battery
¾
replacement takes longer, the appliance must be
reprogrammed.
16 GB/IE
button you can jump
8
button you can
2
symbol flashes, irrigation is
§ Troubleshooting
Fault Possible cause
No indications on No batteries
the display inserted
2
Batteries are
discharged
Irrigation does Water tap
not commence closed
Incorrect
programming
No batteries
or discharged
batteries
§ Cleaning and care
CAUTION! Possible damage to the appliance.
Moisture can cause damage to the appliance. To avoid
irreparable damage to the appliance, ensure that no
moisture can penetrate into the battery compartment
during cleaning.
Clean the housing only with a soft damp cloth and a
¾
mild detergent.
Do not use any solvents, petrol or similar items. This
¾
would damage the device.
§ Cleaning the sieve
11
The sieve should be checked regularly and
¾
cleaned when necessary.
Close the water tap.
¾
Allow the appliance to drain.
¾
Unscrew the union nut
¾
water tap or the adapter.
Remove the cone-shaped sieve from the water supply
¾
in the union nut.
Clean the sieve.
¾
Replace the sieve.
¾
Screw the union nut onto the thread of the water tap
¾
or the adapter.
Open the water tap.
¾
Solution
Insert batteries
Replace the
batteries
Open the water
tap
Check the
programming
Insert/replace
batteries
10
1
from the thread of the