Loading The Ribbon; Loading The Media - Bematech LB-1000 Guía De Referencia Rápida

Loading the Ribbon

(1) Open the printer top cover by pressing the (2) Insert the paper core to the ribbon rewind
top cover open tab s located on each side of spindle.
the printer.
(4) Push the print head release button to open (5) Insert the ribbon to the ribbon spindle.
the print head mechanism.
(7) Pull the ribbon through the print head and (8) Turn the ribbon rewind hub until the ribbon
then stick the ribbon onto the ribbon re wind plastic leader is thoroughly wound and the
paper core. Keep the ribbon flat and without black section of the ribbon covers the print
wrinkles. head.

Loading the Media

(3) Insert the left side of ribbon rewind spindle to
(1) Open the printer top cover by pressing the
the ribbon rewind hub first then insert the
top cover open tabs located on each side of
right sid e of ribbon rewind spindle to the hole
the printer.
at the right side of ribbon mechanism.
(4) Push the print head release button to open
(6) Insert the left side of ribbon supply spindle to
the print head mechanism.
the ribbon supply hub first then insert the
right side of ribbon supply spindle to the hole
at the right side of ribbon mechanism.
(7) Use "Diagnostic Tool" to set the media sensor type and calibrate the selected sensor. (Start the "Diagnostic tool"
Configuration" tab
Note: Please calibrate the gap/black mark sensor when changing the media. In case of changing the ribbon, the calibration process is not
necessary.
(9) Close the print head mechanism by both
hands and make sure the latches are
engaged securely.
(2) Insert the media supply spindle into the paper
roll and use two fixing tabs to fix the paper roll
onto the center of the spindle.
(5) Feed the paper, printing side face up, through
the media bar, media sensor and place the
label leading edge onto the platen roller. Move
the media guides to fit the label width.
Click the "Calibrate Sensor" button ) Please refer to the diagnostic utility quick start guide for more information.
(3) Place the paper roll onto the paper roll
mount. (If your paper width is 4 inch, you
can remove the fixing tabs from the supply
spindle.)
(6) Close the print head mechanism by both
hands and make sure the latches are
engaged securely.
Select the "Printer
P/N: 501012500