Limit Switch Adjustment; Ground Connection; Disposal Of The Product - Allmatic I2500 Manual De Instrucciones

MOTOR AND RACK FITTING
The rack shall be fitted over the motor support, at a certain distance from It.
Its height can be adjusted thanks to the holes In the rack.
The height adjusting is necessary to prevent the gate leaning on the driving gear
(5 and 6).
To fix the rack on the gate, drill some Ø 5 mm holes and thread them using an
M6 screw tap.
ATTENTION!
As shown in FIG. 6, the driving gear needs to be adjusted at 1,0 / 2,0 mm from
the rack. Open and close the gate manually and check that the coupling between the
pinion and the rack is stedy and smooth throughout the motion. This allows you to avoid
that the weight of the gate weigh down on the automation and damages the internal
mechanics.

LIMIT SWITCH ADJUSTMENT

To adjust the assembly (fig. 7): release nuts G, after establishing the direction of
movement of cam H for opening and closing, position the two limit switches, F,
by turning knobs P and judging by sight.
After checking for correct operation of the two microswitches, precisely adjust
their positions so that the gate will stop in the desired position during opening
and closing. Then fasten nuts G.
N.B. The standard limit switch is used for gates up to 10,5 meters long.

GROUND CONNECTION

The system must be grounded.
Use the screw shown in figure 8 to connect the gearmotor to the ground system.
MAINTENANCE
To be carried out exclusively by skilled persons after the power supply to
the motor has been interrupted.
Periodically, when the gate is standstill, clean and keep the guide free from stones
and dirt.

DISPOSAL OF THE PRODUCT

This product is an integral part of the automation, and therefore, they must
be disposed of together. As for the installation operations, at the end of
the life of this product, the dismantling operations must be performed by
qualified personnel. This product is made from different types of materials:
some can be recycled, others must be disposed of. Please inform yourselves
on the recycling or disposal systems provided for by the laws in force in your
area, for this category of product.
CAUTION! – some parts of the product can contain polluting or dangerous
substances which, if dispersed in the environment, may cause serious harm
to the environment and human health.
As indicated by the symbol at the side, it is forbidden to throw this
product into domestic refuse. Therefore, follow the "separated
collection" instructions for disposal, according to the methods
provided for by local regulations in force, or redeliver the product to
the retailer at the moment of purchase of a new, equivalent product.
CAUTION! – the regulations in force at local level may envisage heavy
sanctions in case of abusive disposal of this product.
10/20
374
Measurements in mm
Measurements in mm
ITA ENG FRA ESP
224
1mm...2mm
Ground
connection
DEU POR
6-1624012
75
FIG. 5
FIG. 6
FIG. 7
FIG. 8
rev.4 08/10/2019