General Information About Programming; Programming; Call For The Programming Mode; Programming Mode - Phoenix Contact MCR-SL-D-SPA-UI Manual De Instrucciones

3.3 General Information about Programming

Note
⇑
⇑

4 Programming

4.1 Call for the Programming Mode

To call the programming mode:
1. Press simultaneously both front
side keys and hold them pressed
for at least 3 seconds.
⇑
⇑
2. The following message is displayed
3. In addition, a blinking request for
confirmation is displayed. Press
the right key to switch over bet-
ween YES and No
⇑
4. If YES is displayed and both keys
are pressed, the programming mode
is called for. no exits the program-
ming mode
⇑ ⇑

4.2 Programming Mode

1. Press the right key and select the
operating mode:
⇑
When this manual instructs
to press both keys simulta-
neously, press the left key
slightly before the right key.
2. 3 operating modes are available:
3. After selecting the operating
mode, press both keys.
Programming can start now.
⇑ ⇑
The three operating modes can be
programmed independently of
each other.

4.2.1 The SEtP Operating Mode

1. The following parameters can be
programmed for the SEtP mode:
⇑
⇑
⇑
to
for mA 24.00
to
for mA 24.00
5