Thermador Masterpiece HDDB30WS Manual De Instrucciones página 13

Installation
Determine installation height
16
1
⁄ "
2
(420)
3 1 ⁄ "
4
(83)
30" (762) min over a electric cooktop
30" (762) min over a gas cooktop
The igure above indicates a typical installation of the hood.
NOTICE: The hood could incur some damage from heat
if a THERMADOR MASTERPIECE ® series cooktop is opera -
ted with multiple burners at high settings under a hood that
is installed at minimum clearances.
Wall Installation
1 . Turn power OFF at the service panel. Lock service panel
to prevent power from being turned ON.
2 . Ensure that the installation height of 3 0 " (7 6 2 mm) from
the bottom of the hood to the cooking surface will be
maintained.
3 . Mark a reference centerline on the wall.
4 . Tape template in place, aligning the template centerline
and bottom of template with hood bottom line and with
the centerline marked on the wall.
DRILL 4 (TWO) 3 / ˝ (4.8 mm) PILOT HOLES THROUGH
16
STUDS OR REAR WALL SUPPORTS
PERCER QUATRE (4) AVANT-TROUS DE
DANS LES MONTANS OU LES SUPPORTS DU MUR
ARRIÈRE
HAGA 4 ORIFICIOS DE
SOPORTES DE LA PARED TRASERA
ALIGN BOTTOM EDGE WITH PENCIL LINE INDICATING
BOTTOM OF THE HOOD
ALIGNER LA LIGNE HORIZONTALE AVEC LA LIGNE DE
CRAYON INDIQUANT LA PARTIE INFÉRIEURE DE LA HOTTE
ALINEE LA LÍNEA HORIZONTAL CON LA LÍNEA DE LÁPIZ QUE
INDICA LA PARTE INFERIOR DE LA CAMPANA
HORIZONTAL LINE / LIGNE HORIZONTALE / LINEA HORIZONTAL
A. Centerline
B. Fastener locations
C. Mounting height reference (hood bottom line)
⁄
/ "
1
4
(6.4)
A
DIM0139475
10 / 1 ˝ (256 mm)
16
REAR WALL
MOUNTING TEMPLATE
GABARIT DE MONTAGE
DU MUR ARRIERE
PLANTILLA DE MONTAJE
3 / ˝ (4.8 mm) PARA PARED POSTERIOR
16
3 / ˝ (4.8 mm) SOBRE LOS
16
NOTE: TEMPLATE MAY NOT BE TO SCALE.
MEASURE ALL DIMENSIONS.
REMARQUE: LE MODÈLE NE POURRAIT PAS ÊTRE
EN ÉCHELLE. MESUREZ TOUTES LES DIMENSIONS.
NOTA: LA PLANTILLA PUEDE NO ESTAR A ESCALA
REAL. EFECTUE TODAS LAS MEDICIONES.
10˝ (254 mm)
INSTALLATION HEIGHT / HAUTEUR DE L'INSTALLATION
ALTURA DE INSTALACIÓN
B
C
⁄