Alpine VPE-S431 Manual De Operación página 4

VISUAL EFFECT
(Visual Effect Mode)
For a visual source, Visual Effect is applied to each
monitor.
• When the VISUALIZER mode is on, VISUAL EFFECT is
canceled.
• When no image is input, the picture in VISUAL EFFECT
may be distorted. This is not a malfunction. In this case,
set VISUAL EFFECT with an input image, such as DVD.
• This function cannot be set in the navigation mode.
• When VISUAL EFFECT is set to on, the visual source of
the rear monitor automatically changes to the same
source as the front monitor.
VISUALIZER
You can select your desired mode from MODE1
through 6.
SCAN: MODE1 to 6 are automatically switched.
• When the VISUAL EFFECT is on, the VISUALIZER mode
is canceled.
AUX IN-1,2,3 SIGNAL
Set the video output configuration to NTSC or PAL
according to the type of television and the disc
recording method.
• The image output configuration must be correct. Otherwise
the following message appears and playback does not
start: "VIDEO SIGNAL SYSTEM IS NOT CORRECT".
• The system is set to NTSC at time of shipment from the
factory. Change the system to PAL, as necessary.
AUX IN-1,2,3 NAME
When more than one external device is connected, you
can name each (up to 3) as you like.
AUX / VCR / GAME-1,2 / TV/ NAV. *
• The selected source name is displayed instead of the AUX
source name.
* When IVA-D300 series is connected, "NAV." can be set
only in AUX-3 mode.
Switching the Remote Sensor
When an Alpine monitor which does not work with the touch
panel is connected, the remote sensor can be switched by
connecting the Monitor Control 1,2 lead to a push switch, or
similar (sold separately).
1
Press the Monitor Control 1 or 2 switch.
While the switch is on, the remote sensor of the
rear monitor connected to AUX OUT 1 or 2 is prior
to the other, and the monitor can be operated with
the remote control.
Installation
Screw-down Mounting
1
Using the unit as a template, hold it at its
mounting location and mark the holes to be
drilled. Before drilling, make sure that there
are no objects that could be damaged behind
the mounting surface.
2
Drill holes and secure the unit with the self-
tapping screws (M4 x 14) supplied.
3
-EN