Fellowes POWERSHRED 74C Manual De Instrucciones página 3

BASIC SHREDDING OPERATION
Insert waste bag (Fellowes #36052) for easy disposal.
PAPER,
1
Continuous operation:
10-12-minute maximum
NOTE: Shredder runs
briefly after each pass to
Plug in and put
clear entry. Continuous
disconnect power
operation beyond
switch in ON (I) position
10-12-minutes will trigger
20-minute cool down
period.
TROUBLESHOOTING
A B C
Paper jam: Set to Off (O) and empty bin. Replace bin and follow the procedures below.
1 2
Press and hold Gently pull uncut paper
Reverse (R) from paper entry.
BASIC PRODUCT MAINTENANCE
OILING SHREDDER
performance. If not oiled, a machine may
experience diminished sheet capacity, intrusive
noise when shredding and could ultimately
recommend you oil your shredder each time
you empty your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of defects
in material and workmanship and provides service and support for 1 year from the date of purchase
by the original consumer. Fellowes warrants the cutting blades of the machine to be free from defects
in material and workmanship for 5 years from the date of purchase by the original consumer. If any
part is found to be defective during the warranty period, your sole and exclusive remedy will be repair
cases of abuse, mishandling, failure to comply with product usage standards, shredder operation using
an improper power supply (other than listed on the label), or unauthorized repair. Fellowes reserves the
CARD or CD
2 3
Set to Auto-On (I) Feed into paper
entry and release
A. Safety lock: Make sure safety lock is in unlock position
B. Paper jam: Either press Reverse (R) and remove paper or follow Jam Buster instructions below
C. Overheat: Wait 20 minutes for motor to cool down
D
D. Door open: Make sure bin is pushed in
3
If unable to remove paper, alternate
slowly back and forth between
Auto-On (I) and Reverse (R)
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
Set to Off (O)
4 5
or
Hold card/CD at edge
cards, rotate safety flap
in CD flap into place
4
5
Set to Off (O)
3
2
Set to Reverse (R)
* Apply oil
2-3 seconds
across entry
right to charge the consumers for any additional costs incurred by Fellowes to provide parts or services
outside of the country where the shredder is initially sold by an authorized reseller. ANY IMPLIED
law. For more details or to obtain service under this warranty, please contact us or your dealer.
6 7
Feed into center of Set to Off (O)
entry and release
6
Gently pull uncut paper
from paper entry.
3