Tabla de contenido
Publicidad
BASIC SHREDDING OPERATION
PAPER OR CD/CARD
1
Continuous operation:
10-12-minute maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Plug in and put
Continuous operation beyond
disconnect power
10-12-minutes will trigger
switch in ON (I) position
20-minute cool down period.
ADVANCED PRODUCT FEATURES
SAFESENSE
®
TECHNOLOGY OPERATION
Stops shredding immediately when hands touch the paper opening.
SET-UP AND TESTING
1
2
12
Touch test area and
Turn the shredder ON
look for the SafeSense
( I) to activate
indicator to illuminate
SafeSense
®
BASIC PRODUCT MAINTENANCE
OILING SHREDDER
All cross-cut shredders require oil for peak performance.
If not oiled, a machine may experience diminished
sheet capacity, intrusive noise when shredding and could
ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty
your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
TROUBLESHOOTING
A
B
C
PAPER JAM
1
2
Press and hold
Alternate slowly back and forth
Reverse (R)
2
Check paper amount
Press Auto-On (I)
3
12
SafeSense
is active
®
and working properly
®
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
Set to Off (0)
D
4
3
Set to Off (O)
and unplug
3
4
12
12
Feed paper straight into
paper entry and release
2
3
12
*Apply oil across entry
Set to Reverse (R)
for 2-3 seconds
A. Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum
operating temperature and needs to cool down. This indicator will remain illuminated and the shredder will
not operate for the duration of the recovery time. See Basic Shredding Operation for more information
about the continuous operation and recovery time for this shredder.
B. Bin Open: The shredder will not run if the bin is open.
When illuminated, close the bin to resume shredding.
C. Remove Paper: When illuminated, press reverse (R) and remove paper.
Reduce paper quantity to an acceptable amount and refeed into paper entry.
Indicator: If hands are too close to the paper entry, the SafeSense
D. SafeSense
®
and the shredder will stop shredding.
5
6
12
Gently pull uncut
Press and hold
paper from paper
Reverse (R)
entry. Plug in.
5
6
or
12
Feed into card/CD
When finished
entry and release
shredding set
to OFF (O)
indicator will illuminate
®
3
Publicidad
Tabla de contenido
