Axis 1650 Manual Del Usuario página 15

AXIS 1650 Set-up Instructions
Note: When waking up from Power Off or Energy Save mode, the Canon device needs some
time (from 30 seconds to a few minutes) to adjust the light and the scanner to produce
optimum scans. Press [Start] repeatedly until scanning starts.
Starting a Scan from your Computer
When you have established a connection between your computer and the scanner with AXIS
ScanClient, place the object to be scanned on the scanner flatbed.
On your computer, start the receiving program (e.g.
Canon MF Toolbox — Scan
open the Save dialog.
Scanning
1. In the Save dialog, click [Start] to start
scanning.
When ready, close the Save dialog and the
Canon MF Toolbox. End the scanning session
(see below) and remove the scanned object from
the flatbed.
Ending a Scanning Session
End a scanning session by clicking [Disconnect] on
the AXIS ScanClient.
The message line will change to Disconnected.
Note: The scanning session will automatically end and the channel will be disconnected by
default after 5 minutes of inactivity.
Function). Click [Save] to
Page 15