Operation; Adjusting Gain; Adjusting Crossover Frequency; Infrasonic Filter - Rockford Fosgate TYPE RF X5 Manual De Instalación Y Funcionamiento

O
PERATION

ADJUSTING GAIN

To adjust the gain setting, turn the amplifier gains all the way down. Turn the source unit volume up
until distortion is audible and then turn it down a bit until the distortion is inaudible. This will be
about two thirds all the way up on most source units. Next, turn the amplifier gain setting until once
again distortion is audible and then back it down until the distortion is inaudible. Rockford Fosgate
source units do not distort, so the volume can be used at maximum setting.
NOTE: For a more in depth setting procedure, contact Rockford Technical Support.

ADJUSTING CROSSOVER FREQUENCY

The crossover frequency can be adjusted between 40-250Hz. The crossover is set to LP (Low Pass)
operation only.
Turn the crossover adjustment knob all the way down. With the system playing, turn the crossover
adjustment knob up slowly until the desired crossover point is achieved.

INFRASONIC FILTER

Placing the switch to "ON" engages a infrasonic filter limiting the amount of low frequency
information going to the woofer. Set this to your personal preference while listening to the system
one way, then the other.
C O
OLOR PTIONS
Personalize your Type RF amplifier by
changing the top and corner plastics to
Screw
different colors. Available through our web
site or local retailer.
The corners can be changed by removing the screw
at the bottom, pull the old corner up and out, install
the new corner, and reinstall the screw.
The top plastic requires you to remove the casing
from the amplifier. Do this by removing the four (4)
3/16" allen screws from each corner. Remove the
screw holding the top plastic in place, pull the old
top up and out, install the new top, ensure the top
fits into the notches at the back, and reinstall the
Allen
screw. Reinstall the casing and the four (4) allen
Screw
screws.
8