HURAKAN KTB/K T-255 Manual De Instrucciones página 7

EN
5. Preparing the product for work. Operation procedure
Remove the packaging, assemble the product according to the assembly diagram, the product is
ready for operation.
6. Maintenance
Maintenance and repair of the tables is carried out by specially trained personnel.
The scheduled maintenance and current repairs are carried out according to the approved
structure of the repair cycle. Monthly check the reliability of fastening the connections.
The manufacturer systematically works on improving the design of the products, examines the
experience of operation with consumers and will be grateful for suggestions aiming at
improving it.
The manufacturer reserves the right to make changes in the design of the products without
reflecting them in the operation manual of this product.
7. Packaging, transportation and storage
The HURAKAN table is packed in corrugated cardboard and polyethylene film
7.1. Transportation of products can be executed on any mode of transport with observance of
measures of protection against atmospheric precipitation and mechanical damage in two tiers.
7.2. The product should be stored in the warehouse in a packaged state in a vertical position in
two tiers at a temperature of -30 to +40° C, at a relative humidity of not more than 80% at
20°C and in the absence of aggressive vapors in the air, harmful to the material of the product.
8. Warranty obligations
Warranty period is 1 year from the date of commissioning, but not later than 6 months from the
date of manufacture. In the absence of an act of putting into operation, the warranty period is
calculated from the moment of purchase.
During the warranty period of the product, the supplier guarantees the unpaid repair of
identified manufacturing defects or the replacement of the product under a separate certificate
or contract between the consumer and the supplier.
The warranty does not cover those cases when the product has failed due to the fault of the
consumer as a result of non-compliance with the requirements specified in this manual.
THE TIME SPENT BY THE PRODUCT IN THE REPAIR IS NOT INCLUDED INTO THE
WARRANTY PERIOD.
In case of impossibility of elimination of the revealed defects on the spot the manufacturer
undertakes to replace the product as a whole.
Complaints to the manufacturer shall be made in the manner and within the time periods
stipulated in the "Instruction on the procedure for acceptance of products of industrial and
technical designation and consumer goods according to quality".
7