Electromagnetic Fields (Emf); Preparing For Use; Setting The Clock Time - Philips HF3463 Manual De Instrucciones

EnglisH
8
automatically. Remove the cause of overheating, unplug the appliance and let it cool down for
approx. 20 minutes. Then switch the appliance back on by plugging it in again.
- This appliance allows you to choose the light intensity level you want to wake up to (see section
'Setting the light intensity level' in chapter 'Using the appliance').
- If you often wake up too early or with a headache, reduce the light level.
- If you share a bedroom with someone else, this person may unintentionally wake up from the
light of the appliance, even though this person is further removed from the appliance. This
phenomenon is the result of differences in light sensitivity between people.
- If you start having trouble waking up again, this is possibly due to a decrease in the lamp's light
output that occurs after some time. In that case, you can increase the light level or replace the
lamp.
- If the appliance is used in an industrial area and/or near a power station, it may occur that, under
certain circumstances, the lamp goes off after it has come on. This does not have an adverse or
harmful effect on the safe functioning of the appliance the next time it is used.

Electromagnetic fields (EMF)

This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled
properly and according to the instructions in this user manual, the appliance is safe to use based on
scientific evidence available today.

preparing for use

Screw the lamp into the appliance before you use the appliance for the first time.
installation
1 Before first use, open the hatch in the back of the appliance (see chapter 'Replacement') and
screw the lamp into the lamp holder.
Note: You find the lamp in a cardboard box inside the appliance.
 Place the appliance at 40-50cm from your head, for example on a bedside table (Fig. 6).
 Put the plug in the wall socket.
The time on the display starts flashing and arrows appear above and below the time to
,
indicate that the clock time has to be set (Fig. 7).
Note: If the display does not light up after you have plugged in the appliance, press the reset button on
the bottom of the appliance.

setting the clock time

1 Use the ^ and the % buttons to set the time.
 Hold the button down longer to put the time forward or backward more quickly.
Note: After you have set the time for the first time, you have to press the 'set time' button before you can
adjust the time again. The time on the display starts flashing and arrows appear above and below the
time to indicate that the clock time can be set.
 When you have set the correct time, press the 'set time' button to confirm the time (Fig. 8).
The time on the display stops flashing and the arrows disappear.
,
Note: If you do not confirm the time, the flashing stops and the arrows disappear after 10 seconds. This
indicates that the time has been set.
The appliance is now ready for use.