Euroflex Monster SC50 Manual De Instrucciones página 19

Using Your SC 50 with Floor Brush
Step 1:
Connect one of the extension tubes
to the hand grip on the flexible steam
hose. To attach the extension tubes
one onto the other or onto the hand
grip, press the locking button ensuring
that it fits into the hole. (See illustra-
tions.) To disconnect, repeat the ope-
ration by pressing the locking button
and pulling the two sections apart.
Security
button
Security
button
Tubos de Extensión
NOTE: Fit floor brush with the angle adapter on
to the extension tube.
Using Your SC 50 with Floor Brush (cont.)
Step 2:
If the angle adapter is not attached
to the floor brush, hold the brush
with its bristles up in your left hand.
With the angle adapter pointing
downward, insert it into the hole in
the back of the brush, then turn the
angle adapter 180°.
Step 3:
Insert the electrical power cord into
the wall outlet. Heating time is appro-
ximately 3-5 minutes with cold water.
Filling the steam generator with hot
water will shorten heat up time.
Attaching a Towel to the Floor Brush
100% white terry cloth towel can be fitted on
this brush so as to absorb the dirt and protect
delicate surfaces. It can also be used on ver-
tical washable surfaces following the same
procedure as for the floor.
OPERATING INSTRUCTIONS
Handle
1. Prepare white terry cloth towel:as shown in
Fig. A.
Fig. A
2. Put the brush on the towel.
Fig. B
3. Fold the towel as shown in Fig. B
Fig. C
4. Fold the other side of the towel as shown
in Fig. C.
Fig. D
5. Place the corner under the cloth holder as
shown in Fig. D.
Fig. E
6. Place the towel around the brush, and
repeat folding the towel as shown in Fig. E.
When folding the towel, leave some slack.
Do not pull tightly around the brush.
19