Polaris 3900 SPORT Manual Del Usuario página 4

Page 4
Quick Installation Instructions
1
Install the Universal Wall Fitting
1. Turn on the filtration pump and flush out the plumbing line.Turn pump off.
2. Remove the Universal Wall Fitting (UWF
into the return opening with the blue restrictor disk in place.
3. Turn the Quick Disconnect clockwise into the UWF
Disconnect will click into place.
2
Adjust Feed Hose To Fit Pool Length
1. Measure the deepest part of the pool. Cut leader hose from the end that attaches to the
feed hose (away from the back up valve) so length is equal to the greatest depth of the
pool.
2. Attach leader hose to feed hose and connect hose to the pool wall at the return line.
Extend hose to farthest point of pool. The hose end must be within 6 inches – longer or
shorter – of the farthest point. See diagram below.
If hose is too long: Separate hose at center swivel. Cut half of the overage from each
10-foot feed hose section that attaches to the center swivel.
If hose is too short: Add a feed hose section (part #9-100-3104), a swivel (part #D20)
and two (2) hose nuts (part #D15). Adjust to proper length.
Each feed hose section should be equal in length after adjustments.
3. After adjusting the length, position the hose floats as shown.
UWF®
Dedicated
Return Line
Restrictor Disk
UWF
Quick Disconnect
Pressure Relief Valve
In-Line Center
Swivel
Filter
Feed Hose Floats
1.5 to 3' apart
) from the Quick Disconnect and screw it
®
and pull away to secure. The Quick
®
Return
Leader Hose
Line
Length = Max. Depth
Leader Hose Floats
2-3' apart
Furthest
Point
®