Omega Lift PRO 80600 Manual De Piezas E Instrucciones De Funcionamiento página 4

OPERATIONAL GUIDANCE CONTINUED
8. Remove the blue plug of Jump Starter cable block from the 12 V Jump Starter socket of the
host and then remove the clamps of Jump Starter from the car battery.
!
WARNING: DO NOT leave the host unit connected to a car battery for more than 15 seconds
or the unit can catch fire. DISCONNNECT the unit within less than 15 seconds of use whether
or not the car starts
NOTICE
If the red and green lights on the black box of the Smart Jump Starter cable are not working during
jump starting the vehicle, please reset the jump starter as follows:
1. Remove the red clamp from the positive (+) terminal of the car battery.
2. Connect the red clamp back on the positive (+) terminal. Now the green light is on again and
the product is ready for use.
NOTICE:
1. Before attempting to start the engine of a vehicle, check that the blue cable plug is fully inserted
into the unit's 12 V Jump Starter socket. Failure to have this properly connected to the unit can
cause a bad connection which may result in failure to start or damage to the unit/plug.
2. If the engine fails to start, (1) check that the Jump Starter power LEDs have at least 3 bars lit,
(2) check that the vehicle is in full working order, (3) check that the vehicle's battery has enough
charge, (4) check that the clamps are fully connected to the vehicle's battery.
3. If the environment ambient temperature is lower than 14°F/-10°C at the location of the car bat-
tery, the vehicle engine may not start on the first try. The vehicle's battery will need to reach a
working temperature in order to be started smoothly .
OUTPUT: USB DC5V/2A
1. Use a USB connection cable to charge 5V mobile phones and other electronic products from
the USB 5V 2A output port of the Jump Starter.
2. Connect the product to the Jump Starter and then press the power switch. The power LEDs
are alight; mean the Jump Starter is charging the product.
LED TORCH
Switch button operating cycle is as follows:
1. Press twice the power switch to start the LED torch.
2. Press once more to enter S.O.S. mode.
3. Press again to turn off the light.
Specification
Output
Input
Charge Time
Capacity
Weight
Dimensions
Starting Current
Peak Current
Suitable Engine
Operating Temp.
Storage Temp.
OR FIRE AND/OR INJURY COULD RESULT!
SPECIFICATIONS
USB - DC 5V / 2A
Jumpstart port (EC5) - DC 12V
DC 5V / 1A
6 hours on 5V/1A
6,000 mAh
8.47 oz.
5.43 x 2.95 x
.63 in
350A
700 A
12V / Gasoline Engine < 5.0 L
-4° F ~ 140° F (-20° C ~ 60° C)
-4° F ~ 176° F (-20° C ~ 80° C)
80600, 80600R
LED Torch
12 V Jumpstart
Socket
USB 5V/2A
Output
4
Power
Indicator
Power
Switch
Micro USB
Input Charge Port