Dust Bag Changing; Replacing Dust Bag - Kenmore 116.21714 Manual De Uso Y Cuidado

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

DUST BAG CHANGING
For best cleaning results, the dust bag should be changed often. The CHECK BAG indicator
light will come on when the dust bag needs to be changed or the airflow is blocked.
NOTE: Use replacement dust bag STYLEQ, see part number detail in REPLACEMENT PARTS
(page 5).
REMOVING
DUST BAG
1. Turn off and unplug vacuum cleaner.
2. Remove hose from canister. (See
ASSEMBLY INSTRUCTIONS, page 8).
3. Pull hood release out and up.
4. Lift canister
hood.
_Hood
5. Pull dust bag out
of the red bag
mount and dispose
of dust bag.
NOTE: Check the
motor safety filter
and replace, if
necessary.(See
MOTOR SAFETY
FILTERCHANGING,
page 22).
NOTE: The red bag mount will flip forward
after removing dust bag. This will prevent
the hood from closing until a new dust bag
is installed.
REPLACING DUST BAG
Note:
DO NOT bend or crease the middle
of the cardboard
when installing the dust
bog into the bag mount slots.
1. Verify that vacuum cleaner isunplugged.
2. Rotate red bag
mount down and
install dust bag into
slots per illustration,
pushing down until
the cardboard
tab
locks into position
and the holes align.
3. Tuck the dust
bag securely into the bag cavity so that
none of the dust bag is able to be pinched
by the hood.
4. Close and latch canister
hood.
5. insert hose into canister
until it snaps in
place. (See ASSEMBLY INSTRUCTIONS,
page 8).
CAUTION
NEVER EMPTY OUT AND REUSE A DUST
BAG. Very fine materlols,
such as carpet
freshener, face powder, fine dust, piaster,
soot, new carpet
llnt, etc. can clog the
dust bag and cause it to burst before it is
full and may cause damage
to vacuum
cleaner
motor. Change dust bag more
often when vacuuming
these materials.
-21 -

Publicidad

Tabla de contenido
loading

Tabla de contenido