Components Of The Baby Monitor - NUK Babyphone Eco Control Audio 530D Manual Del Usuario

3. Components of the baby monitor

1 Baby unit
2 Speaker
– enables you to talk to your baby.
3 Mains adapter socket
4 Nightlight
5 Microphone
6 Lullabies on/off button
– brief press: Switch lullabies on or off
– long press: select the next song
7 On/Off button:
– brief press: switches on;
– long press: switches off.
8 Nightlight on/off button/
Call function of parent unit
– brief press: Switch nightlight on or off
– long press: Activate call function of
parent unit
9 Power LED
– lights up green when the baby unit is
switched on.
10 VOX LED
– lights up green when it has set up a
connection to the parent unit;
– goes out if the connection to the parent
unit is interrupted, the device is
switched off or is in Eco-Mode.
11 Parent unit
12 Battery cover
13 The Vol + button
– increases the volume.
14 The Vol - button
– reduces the volume.
– Switches to mute on the lowest setting.
Sounds are then indicated only by the
LEDs 19.
15 Display
16 Connection indicator
– lights up green when there it a
connection;
– flashes green
connection, Eco-Mode is active and
your baby is asleep;
– lights up red if the connection is lost.
while there is
17 On/off button
18 The power supply indicator POWER
– lights up green: the device is switched
on and the battery is fully charged;
– flashes green: the battery currently
being charged;
– lights up red and beeps at one minute
intervals: low battery warning. Within
about 15 – 20 minutes the parent unit
will switch off automatically.
19 Indicator LEDs
– indicates the noise level in the nursery.
The more LEDs are lit, the louder are
the noises;
– indicates the different levels when you
are adjusting the volume. The more
LEDs are lit, the louder will be the
sound from the loudspeaker;
– indicates the different levels when you
are adjusting the VOX sensitivity. The
more LEDs are flashing, the sooner the
device will react to sounds. If 5 LEDs
are lit the device will switch to
continuous transmission.
20 Press the VOX button
– press briefly and use Vol +/- to set the
transmission sensitivity.
20 VOX button
– press, to use Vol +/- to adjust the VOX
setting;
21 Lullabies on/off button
– brief press: Switch lullabies on or
off;
– press and hold the button to play the
next song.
22 Hold down the TALK button
– Holding down this button activates the
function "talk to baby";
– while the baby unit is in Eco-Mode, the
talk-back function is disabled and this
is indicated by two consecutive beeps.
a
23 Nightlight on/off button
– press: Switch nightlight on or
off;
24 Mains adapter socket
28