Operating Instructions - Magic Chef MCSCM12SS12 Manual Del Usaurio

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING INSTRUCTIONS

MAKING COFFEE MANUALLY
1.
Open the water tank cover and fill to the mark with
clean water.
2.
Add desired amount coffee grounds to nylon filter
according to taste, then set nylon filter into funnel.
3.
Close the water tank cover and plug in the coffee
maker. Display will show 12:00.
4.
Put carafe on the warming plate, making sure that it is lined up with funnel.
5.
Touch "MODE" to select brew strength.
6.
Touch "On/Off" once, the red indicator light will illuminate and the unit will begin brewing coffee.
7.
When the brewing is completed, the coffee maker will go into a "Keep Warm" mode and then turn off after
2 hours.
NOTE: You can remove the carafe at any point in the brewing cycle to pour a cup of coffee, but be sure to put
back in place under the funnel within 30 seconds.
SETTING THE CLOCK AND AUTOMATIC BREWING
The coffee maker can be programmed to automatically begin brewing coffee at a preset time by doing the
following:
1.
Touch "PROG" once and "CLOCK" will appear on the display.
2.
Use the "HOUR" and "MIN" buttons to set the current time. Make sure to set AM/PM for the time.
3.
Touch "PROG" until the display shows "TIMER"
4.
Use the "HOUR and "MIN" buttons to set the desired automatic start time.
5.
Touch "MODE" to select brew strength.
6.
Touch "On/Off" twice. The blue light will come on, and unit will begin brewing coffee at the pre-set time
that was entered. When brewing starts, the red light will turn on.
7.
You can manually start the brewing at any time by pressing "On/ Off twice.
8.
When the brewing is completed, the coffee maker will go into a "Keep Warm" mode and then turn off after
2 hours.
WARNING: DO NOT leave the coffee maker unattended while it is brewing.
is the factory setting,
is the factory setting,
8
is stronger, and
is stronger, and
Figure 1
is strongest.
is strongest.

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido