Tabla de contenido
Publicidad
Normal Stage of Operation
S
Y
M
P
T
O
M
Tool operates properly, but fasteners do not
drive fully.
Tool operates, but no fastener is driven.
Tool operates erratically or appears to be
losing power - tool indicator light is green.
Tool operated and drove fasteners, but
driver blade did not return to up position.
Combustion chamber does not drop after
tool cycles.
P
O
S
S
B I
L
E
P
R
Work-contacting element requires adjustment.
Dirty air filter.
There may be loss of seal in combustion
chamber.
Wrong fasteners being used.
Tool requires cleaning.
Follower not properly engaged behind fastener
strip.
Jammed fastener.
Spark plug wire is loose.
Filter element is dirty, causing tool to overheat.
Built-up dirt and debris on driver blade or in
nose bore.
Mid check is dirty or disabled.
Work-contacting element is bent or is dirty.
Still not working? Here are more options:
•
Your nailer may qualify for our Cordless 2 Year
Service Promise. Visit paslode.com for more
information or call us at 1-800-634-7373.
•
Keep your cordless nailer in top form. Visit paslode.com
and watch our Cleaning and Maintenance videos.
Troubleshooting
O
B
L
E
M
S
Adjust work contacting element.
Clean filter.
Press work contacting element against
workpiece for 20 seconds. Pull trigger. If
fastener does not drive, there is a leak that
requires service.
Use only fasteners meeting Paslode
specifications. Check Fasteners and
Applications section for fastener types and
sizes recommended for use in Cordless tool.
Clean per instructions.
Position follower behind fastener strip and
engage strip.
Clear jam.
Check spark plug wire.
Remove filter element and clean. Use soap
and water to remove stubborn debris.
Clean driver blade and nose bore with
degreaser cleaner.
Return tool to authorized Paslode
dealer for service.
Clean or replace work-contacting element.
S
E
R
V
C I
E
®
Cordless
®
19
Publicidad
Tabla de contenido
