Using An External Effect - Samson SM10 Manual Del Usuario

SM10 Quick Start

USING AN EXTERNAL EFFECT

1. Connect the EFX OUTPUT to the input of the external effect processor.
2. Connect the outputs of the effects processor to channel 9 stereo line input.
3. Set the EFX SEND control to the 12 o'clock position.
4. Raise the EFX knobs for the channels to which you want the external effect to
be applied.
5. Set the input level of the external
effect so that the sound is not
distorted and so that the effect's input
meter does not indicate a clipped
signal.
6. Use the channel 9 Volume control
to adjust the level of the effects
processed by the external effects
device.
7. The EFX bus can be monitored via headphones, by setting the PHONES
SOURCE switch to EFX.
NOTE: Listening to high volume levels through headphones for even a short time
may damage your hearing and/or your headphones. Always turn the HEADPHONE
LEVEL control all the way counterclockwise before connecting your headphones.
Slowly raise the HEADPHONE LEVEL until a comfortable listening level is
reached. Noise over 85 dB can cause gradual hearing loss. Learn to establish a
safe listening level.
14
If you prefer to use an external device for
effects processing, you can easily connect
the unit using the SM10 EFX bus. Follow
the simple steps below to interface your
processor: