Rane BLACK&BLUE Guia Del Usuario página 10

Recording
1. Connect a USB cable from Black & Blue's USB port to an available USB port on
your computer.
2. See the section
Recording Device
3. On your computer, open your preferred recording software.
Note: To hear music while it's playing or to monitor recording content, listen
through your computer's speakers, or connect Black & Blue's Master output to
an amplifier or powered speakers.
Playback
You can listen to the music on your computer through Black & Blue. See the section
Computer Setup > Setting Black & Blue as the Default Playback Device
playing back your computer music.
Euroblock Setup
1. Connect a device to the 1/8" (3.5
mm) TRS Input or pair your
Bluetooth source to Black & Blue.
2. Strip approximately 1/4 inch (6
mm) insulation off the wire ends.
When using stranded wires, twist
the cable ends to form a taut lead.
This will help avoid short circuits
due to loose strands. Insert the
wire end into the appropriate port.
Push the wire until it reaches the
lowest point in connector. Use a
small (-) screwdriver to secure each wire. Ensure the connections fit securely,
but not too tight. Check the connection by attempting to pull the wire out of the
connector. If it comes out, loosen the screw and repeat the process to secure
more firmly.
3. Attach the Euroblock connector to the Amplifier Output on Black & Blue.
4. Make sure all Level knobs are set to "0".
5. Connect the included power cable from the power input to a power outlet;
power on Black & Blue.
6. Adjust the individual channel input Level knobs and the Master Volume knob
to get a strong signal without distortion or "clipping". Reduce the Master
Volume setting when Signal LED continuously illuminates red.
7. Adjust the Low and High tone knobs to contour the sound for your liking.
Note: The Low tone knob affects rumbles, thumps, and other bass sounds.
Reduce this setting when only speech signals are being mixed. The High tone
knob affects brightness and clarity. Reduce this setting when the content
sounds shrill or harsh.
10
Computer Setup > Setting Black & Blue as the Default
to set Black & Blue as the default recording device.
before