Array Rigging - Bose RoomMatch RMS215 Instrucciones De Instalación Y De Seguridad

Installation
pro.Bose.com

Array Rigging

Each RoomMatch™ array module is shipped with integrated side-plate array rigging hardware. The rigging system is designed to
allow fast construction of typical fixed-installation arrays of up to 8 modules, while maintaining a 10:1 Safety Factor. Additionally,
the RoomMatch™ RMS215 subwoofer is designed to integrate with full-range modules in arrays when the optional RMSFLY accessory
part is installed. To connect RoomMatch™ modules for suspended arrays, the following steps are recommended:
Note: Prior installation of field wiring and a safety-rated suspension system, e.g. chain-hoist motors or wire-rope slings, is assumed.
Motors may be used as a permanent suspension method or to temporarily elevate an array to final position for attachment to conven-
tional rigging hardware.
Note: All lifting operations require two individuals positioned on each side of the loudspeaker.
Before You Begin – Recommended Tools
(2) 15 mm sockets and socket wrenches (module to module bolts: M10 x 30 mm)
(2) 17 mm sockets and socket wrenches (if using frame extender bars)
(2) 5/16-inch Aligning Punch (optional; to aid bolt alignment)
Preparing Modules for Installation
Step 1 – Remove the RoomMatch™ modules from the shipping cartons, remove packing materials, and place the loudspeakers on the
floor beneath planned suspension point. Retain orange-color Temporary Installation Handles included in package.
Caution: Do not place loudspeakers resting on grills.
Caution: Place loudspeakers on a flat surface; verify loudspeaker weight is not supported by driver adapters.
Step 2 – Locate the temporary installation handles and thread onto each module rigging side plate (see Figures 3 and 4).
Step 3 – Remove four (4) M10 bolts from top of rigging side plates for each module (2 per side).
Figure 3. Temporary Installation Handles
Figure 4. Installing the Temporary Handles
English Installation and Safety Guidelines Page 11