Ninja 1200MS Manual Del Usuario página 6

CHANGING THE 1200MS PRESSURE PUMP OIL
Tools required:
Manual transfer pump
Clean cloths
Suitable oil waste/recycling container
Verify both tanks are empty. Use a cloth to wipe out any residual moisture. Place clean cardboard or a pad behind unit
to protect handle. Remove retaining nut, hinge open unit and rest on pad.
Remove oil fill cap on pressure pump
Insert suction tube of transfer pump into oil fill hole. Pump out oil to a suitable waste / recycling receptacle.
Insert suction tube of transfer pump into bottle of fresh oil and pump approximately 8 oz. of oil into pressure pump.
After placing approximately 8 oz. of oil into the pump, check
the oil level with the dipstick. Level should be within the
notched area on the dipstick. If necessary, add oil and
recheck with the dipstick until oil is at the correct level.
When filling is complete, reinstall install oil cap, close unit and reinstall retaining nu
The 1200MS is now ready for use.
07-02233B MANUAL - 1200MS 115V PORTABLE
t.
6
Dispose of used oil appropriately.
Ninja