Handset Registration - Clarity XLC3.4+ Manual Del Usuario

R
I D
S
T
E
R
R
S
R
A T
A
R
R
D
R
R
D
A DSET
D
28

HANDSET REGISTRATION

In order to use the XLC3.6+HS (white color) handset (sold
separately), you must register it to the XLC3.4+ base.
Pull the handset's battery tab located on the bottom of
the device, and then press
deregistering your handset from your system.
1. Press
displayed on the screen, "Handset Needs Registration."
2. Press and hold the
seconds, until the base visual ringer starts flashing. Release
3. Press
4. The screen shows "Registering... ", then "Registration
Successful" (accompanied by five quick beeps).
5. Your handset is now registered to your XLC3.4+ system.
Your screen will display "Handset X," (where "X" is the number
of the actual handset registered, such as the second or fourth
handset, etc.).
You can extend the number of handsets by using additional
XLC3.6+HS handsets (sold separately).
1. In standby mode, press
2. Press
"Phone Setup" to the top of the screen.
3. Press
"Register" on the screen's top row now.
4. Press
5. Press
6. Follow the Registration steps listed above.
1. See the six steps listed above, then press
"Deregister."
2.
X Deregistered"(again, where "X" is the number of the handset
registered), then "Handset Needs Registration."
to enter registration mode. You will see
key on the XLC3.4+ base.
key on the handset.
arrow five times to advance the row reading
to enter the setup section. The screen displays
to enter the Registration section.
again to select "Register."
to start registering or
key on the XLC3.4+ base for five
.
. The screen will show "Handset
to select