Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Operating Instructions
Troubleshooting Chart
Symptom
Tool runs slowly or will not
operate
Moisture blowing out of tool
Excessive vibration
Possible Cause(s)
1. Grit or gum in tool
2. No oil in tool
3. Low air pressure
4. Air hose leaks
5. Pressure drops
6. Regulator adjusted
wrong
1. Water in tank
2. Water in the air
lines/hoses
1. Damaged wheel
2. Arbor shaft bent
Corrective Action
1.
Flush the tool with Campbell Hausfeld air tool oil, gum
solvent, or an equal mixture of SAE 10 motor oil and
kerosene. If Campbell Hausfeld oil is not used, lubricate
the tool after cleaning.
2.
Lubricate the tool according to lubrication instructions in
Pre-Operation section.
3.
Adjust the compressor regulator to tool maximum while
the tool is running free.
4.
Tighten and seal hose fittings if leaks are found.
5.
Be sure hose is properly sized. Long hoses or tools using
large volumes of air may require a hose with an I.D. of
1/2 inch or larger depending on total hose length.
6.
Adjust regulator with slotted screwdriver to maximum
speed.
1.
Drain tank (See air compressor manual). Oil tool and run
until no water is evident. Oil tool again and run 1-2
seconds.
2a.
Install a water separator/filter (PA2121). NOTE: Separators
work properly only when air steam is cool Locate
separator/filter as far as possible from compressor.
2b.
Install an air dryer.
2c.
Anytime water enters the tool, the tool should be oiled
immediately.
1.
Replace cutting wheel (MP2879).
2.
Replace tool.
3
www.campbellhausfeld.com
Publicidad
Tabla de contenido
