GE Current Evolve E2SB Guia De Inicio Rapido

Evolve LED
™
Security Light
(E2SB)
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Save these instructions for future use.
Risk of electrical shock. Disconnect power before servicing
or installing product.
Risk of injury or damage. Unit will fall if not installed
properly. Follow installation instructions.
Risk of injury. Wear safety glasses and gloves during
installation and servicing.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation. This Class [A] Lighting Equipment complies with
Canadian standardICES-005[A] / NMB-005[A].
Note: This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
WARNING
WARNING
CAUTION
GENERAL
• This luminaire is for outdoor lighting use. Do not
install in areas of limited ventilation or high ambient
temperatures.
• Install and maintain according to this Guide.
• Install horizontally with LEDs facing down.
SPECIFICATIONS
• Weight: <16 lbs with std 24" mounting arm
7.2 – 7.6 lbs without arm
• Dimensions: L x W x H
W/O Refractor: 14.6 in x 9.7 in x 7.8 in
(371mm x 246mm x 198mm)
W Refractor: 14.6 in x 9.7 in x 10.5 in
(371mm x 246mm x 267mm)
• Ambient Temperature Range: -40°C to +50°C
• Fixture UL: UL Wet Location Rated
• Optical Enclosure is IP65
1
UNPACKING/HANDLING
• This luminaire has been packed to ensure no damage
during transit. Inspect to confirm.
• Do not impact or stack luminaire after removal from
packaging.
2
MOUNTING
2a. ARM INSTALLATION (Mounting to a wooden pole)
• Drill a 3/4-inch dia. hole through the wood pole.
Insert 10-inch bolt through pole and loosely fasten
with 2-inch square washer and nut.
• Hook the upper slot of the arm's pole plate on the bolt
head (See Figure 1). Tighten nut to secure mounting
arm to pole.
• Hammer in lag bolts thru lower plate holes to about 1"
of head then tighten with wrench.
Installation Guide
GEH-6063