ASROCK ALiveXFire-eSATA2 Manual De Instrucciones página 21

2.9 Onboard Headers and Connectors 2.9 Onboard Headers and Connectors 2.9 Onboard Headers and Connectors
2.9 Onboard Headers and Connectors 2.9 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
•
Floppy Connector
(33-pin FLOPPY1)
(see p.2 No. 25)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.2 No. 9)
connect the blue end
to the motherboard
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATAII Connectors
(SATAII_BLUE (PORT 4):
see p.2, No. 21)
(SATAII_BLACK (PORT 3):
see p.2, No. 16)
(SATAII_RED (PORT 1):
see p.2, No. 15)
(SATAII_ORANGE (PORT 2):
see p.2, No. 14)
SATAII_RED (PORT 1) and SATAII_ORANGE (PORT 2) connectors can be
used for internal storage devices or be connected to eSATAII_BOTTOM
and eSATAII_TOP connectors with corresponding color to support eSATAII
devices. Please read "eSATAII Interface Introduction" on page 27 for
details about eSATAII and eSATAII installation procedures.
eSATAII Connectors
(eSATAII_TOP: see p.2, No. 35)
(eSATAII_BOTTOM: see p.2, No. 36)
ASRock ALiveXFire-eSATA2 Motherboard
80-conductor ATA 66/100/133 cable
These four Serial ATAII
(SATAII) connectors support
SATA data cables for internal
storage devices. The current
SATAII interface allows up to
3.0 Gb/s data transfer rate.
These two eSATAII
connectors support SATA
data cables for external
SATAII function. The current
eSATAII interface allows up to
3.0 Gb/s data transfer rate.
the red-striped side to Pin1
connect the black end
to the IDE devices
2 1 2 1 2 1
2 1 2 1