Charging The Car Jumper; Charging A Phone Tablet Or Other Usb Device; Charging A Laptop - Freeman P800AJS Manual De Instrucciones

MODEL: P800AJS
on the engine.
NO LIGHTS ON AND NO BUZZING:
The battery may be to low. Make sure the clamps
are connected correctly, press the "BOOST" button
and wait for the GREEN LIGHT to come on. If the
light does come on, turn on the engine within 30s.
If the light does not come on, take the vehicle to a
certified mechanic or consult the owner's manual.
Boost Button
Correct Light
Reverse Light
4. Start the car engine. If after 3 seconds engine does
not start, turn key to "OFF" position. Detach the car
jumper clamps, then restart steps 1-4.
10
HTTP://WWW.FREEMANTOOLS.COM
5.
Remove the clamps from the battery terminals.
6. Unplug the cable plug from the jump starter.
1-888-669-5672
MODEL: P800AJS

CHARGING THE CAR JUMPER

1.
Plug wall charger/car charger cable into the wall/
car input. Then plug the cable into the input port of
the car jumper. The light indicator should start to
blink while the jumper is being charged.
CHARGING A PHONE, TABLET, OR
OTHER USB DEVICES
1. Plug the USB cable into the USB output on the
jump starter. Then insert charging cable into the
device that needs to be charged. Press the power
button on your jump starter and the device will
begin to charge.
HTTP://WWW.FREEMANTOOLS.COM
CHARGING A LAPTOP OR OTHER
DEVICE
1. The car jumper comes with 8 adapter tips and an
adapter cable to charge 19V and 12V devices. The
car jumper also has two outputs (12V and 19V).
Check the device's voltage and current output
rating and plug the adapter into the appropriate
output. Then choose the appropriate tip that
matches the input of your device and plug it in.
Turn on the car jumper and the device will will start
to charge.
1-888-669-5672
11