Publicidad
Idiomas disponibles
Idiomas disponibles
Next steps on installation:
a) Connections on the multiport valve:
1. Make sure power supply is off.
2. Remove the 4 bolts that fix the blue&transparent cover (one on each corner) using a
suitable screwdriver.
3. Pick the cover up slowly and remove the tape connector from the Electronic board.
Fig 2.- Separate the tape connector from the Electronic board.
15/12/2010
Fig. 1.- Unscrew the 4 bolts that fix the cover
Página 2 de 19
Installation Manual
BASIC Automatic
Multiport Valve
Rev 3.0
Publicidad
